search shadow

Comments

1 comment

  • Official comment
    Avatar
    David Velasco

    This question was recently brought up to us, so I figured we should add it to the Forum.

    The pin on top of the Eco Release should just be hand-tight.  You do not need to tighten it very hard.  Simply screw it down onto the top of the Release until it reaches the bottom.  Note that in order for you to install the shackle, you may need to unscrew the pin a little so that the hole aligns with the notch on the top of the Release (see image below from the Video Manual).  This may leave a small gap of as much as ~1 mm between the pin and the Release--this is normal!  There are enough threads on the Release screw to hold the pin in place even with this small gap.

    Comment actions Permalink

Please sign in to leave a comment.