Nortek Support
- Total activity 170
- Last activity
- Member since
- Following 0 users
- Followed by 0 users
- Votes 0
- Subscriptions 0
Articles
Recent activity by Nortek Support Sort by recent activity-
Integrators Guide - Aquadopp 2
DescriptionThis document is aimed at system integrator and engineers giving an overview of data formats and commands needed to control and configure the instrument. Please note that we are constant...
-
What is multiplexing for my Signature instrument?
Multiplexing means that the instrument pings the transducers either one by one or two by two, and then estimates the three-dimensional velocity after a full cycle of pinging all the beams has been ...
-
What does Long range mode mean for my Signature instruments?
The Signature series allows the possibility to operate with two different band widths in the same deployment when using concurrent or alternating plans. To remove any confusion we use the term lo...
-
When should I use the "Waves - static mode" for my AWAC?
Wave Static Mode is designed for specific conditions where the surface position is relatively predictable, and the user wishes to define a measurement window around this known surface, including th...
-
How does the configuration affect the lag between pressure and velocity measurements when measuring waves with PUV?
The pressure sensor in the Aquadopp and Aquadopp Profiler (Generation 1, pre-2024) is sampled 80 ms after the start of each sample interval. The lag between pressure and velocity depends on the mea...
-
What is the maximum sampling rate for current profiling and bottom track with a Nucleus?
The maximum sampling rate for current profiling (ADCP) or bottom tacking (BT) depends on a variety of factors, including the configured BT range and the use of an altimeter(ALT). If you are oper...
-
Integrators Guide - AWAC 2
DescriptionThis document is aimed at system integrator and engineers giving an overview of data formats and commands needed to control and configure the generation 2 AWAC. For information about the...
-
Operations/Integration Manual - Nucleus
DescriptionThis manual is designed to help users of the Nucleus to get familiar with the system, and to integrate it with remotely operated or autonomous vehicles. InstrumentsNucleus Date21.08.2024...
-
What is the Echosounder mode? How to use data from the Echosounder?
The Nortek Signature 1000, Signature 500 and Signature 100 are equipped with active acoustics technology, commonly referred to as Echosounder. An Echosounder can generate, amplify and transmit high...
-
How do I take care of my connectors?
Nortek supplies two types of cables - Subconn and Impulse. In this article, we have highlighted a set of instructions on how to take care of each connector type. To identify which cable you have...