Velocimeters
Find answers to your questions about velocimeters
- Recording binary (.vec) and ASCII (.vea) files correctly
- Does the Vectrino flag bad data?
- The Vectrino probe is not recognized. What is the problem?
- What does the accuracy specification mean?
- How do I set up analog output on and what do the values mean?
- How do I synchronize Vectrinos?
- How do you figure out the time to assign to Vector velocity samples?
- How are the amplitude [dB] and correlation [%] calculated?
- Can I obtain signal and noise information separately?
- Does the accuracy differ with profiling range?
- How can I make sure the Vectrino Profiler is not tilted?
- How do I identify weak spots in Vectrino Profiler data?
- How do I get directional wave spectra from Vectrino Profiler data?
- How does the Vector coordinate system work?
- How do I change probes on my Vectrino?
- Why does the distance check show the wrong values?
- What is the difference between Z1 and Z2?
- What are the differences between and advantages of side-looking and down-looking Vectrino probes?
- What are weak spots and how can I avoid them?
- What exactly is meant by “Distance from the sample volume”?
- What is the maximum velocity range supported by a Vectrino Profiler?
- What do the error messages for the Vectrino Profiler mean?
- Does the maximum sampling rate decrease with increasing profiling range?
- How do I enhance Correlation and SNR?
- Measure on sync is not working?
- How do I remove the ambiguity velocity/phase wrapping from my data?
- How does a Pulse-Coherent system use lags to determine maximum velocity range?
- What is the relationship between the nominal and the vertical & horizontal velocity range?
- How much seeding is needed?
- Can I use the Vectrino/Vectrino Profiler in coastal water?