Data quality control and post-processing
- What are the steps to collect Echosounder data?
- How to estimate Suspended Sediment Concentration (SSC) using Nortek instruments?
- What is the Echosounder mode? How to use data from the Echosounder?
- Where are the depth cells positioned in Seareport?
- What are amplitude and correlation, and what do they tell us about data quality?
- Why does my data have low SNR?
- How do blockages affect my data?
- What is acoustic interference? Why does it occur and how to avoid it?
- What is drag down? Why does it occur and how to avoid it?
- What do pitch, roll, and heading tell us and what are they used for?
- QA/QC current measurement (short version)
- QA/QC current measurement (comprehensive)
- How do I exclude one beam from processing in Storm and Ocean Contour?
- What is bin mapping?
- What happens when my instrument is tilted and what actions should I take?
- What noise floor is used during processing in SeaReport?
- How does SeaReport calculate tilt?
- What is phase wrapping and phase ambiguity? How can I solve it?
- What do the SeaReport Quality Codes mean?
- What is the AST Quality parameter, and what can I use it for?
- What is the difference between AST and LE?
- Does "white-capping" cause problems for the AST beam?
- How can sediment affect my measurements?
- How does the AWAC estimate ice thickness?
- What do the Error and Status codes mean?
- What is the difference between the raw and the processed AST time series?
- How does Storm calculate the Signal to Noise ratio (SNR)?
- Why does my AWAC AST appear to miss the surface and have bad/missing detects?
- What do the Wave Error Codes mean?
- What is the difference between Hm0 and Hs?